Gypsum retarder and enhancer2020年9月21日
TR6 Small Concrete Foaming Generator introduce:
Overview of TR6 CLC Foam Generator:
Foam Concrete Machine is the core equipment of foam concrete production, which has a significant impact on the quality of foam concrete. An excellent foam generator for concrete not only has a high foam output but more importantly, the quality of the foam produced is outstanding. TR6 portable foam generator developed by our company. It can be used in laboratories, small-scale foam concrete cast-in-situ projects, and pilot lines of foam concrete products. The outstanding advantages of TR6 portable foam generator are low foam moisture content, more foaming agent, high foam uniformity, large foam output, and other benefits.
Data of TR6 CLC Foam Generator:
|Maximum foam output(m3/h)||6|
Usually need to be disassembled:
1. After working for a long time, it is found that the foam shape is not good, usually more than three months.
2. Pipe blockage: Some foaming agent remaining in the bubble tube will form a solid residue. In this case, the foam cannot be produced normally, or the pipeline pressure increases sharply. At this time, all the old steel balls need to be taken out, and then replaced with a new one The ball is fine. Steel wire ball specification requirements: each blowing tube needs to be filled with about 12-15 steel wire balls. Too much or too little will affect or even destroy the foam performance.
1. Remember to use electricity safely. If water or foam touches the circuit, you must immediately cut off the power at the remote end to ensure safe production.
2. There will be air in the pipeline when it is used for the first time. The foaming liquid has not been pumped into the equipment in a short time. You can wait for tens of seconds until the liquid is filled with the entire suction tube and the foaming operation can be performed normally.
3. Do not start the equipment when the pipeline is blocked to prevent damage to the components due to overpressure in the pipeline.
The aerogel material is prepared by using inorganic fiber reinforcement technology, which is prepared by dipping sol, gel, solvent replacement, and supercritical drying process. It has the characteristics of low thermal conductivity, high water repellency, good shock absorption, and natural fire resistance. At the same time, flexible or rigid inorganic fiber reinforced aerogel materials can be produced according to requirements.
Hot Tags: High temperature resistant aerogel felt, manufacturers, suppliers, factory, Customized
Vitae ultricies eu, faucibus quis, porttitor eros cursus lectus, pellentesque eget, bibendum a, gravida ullamcorper quam.